- February 20th, 2022, 2:23 pm#4967511
Could you provide a list of which components from the original electronic kit from Sean you replaced and what you replaced them with?
BrettRogersUK wrote: ↑March 7th, 2024, 10:46 am Hi,Hi Brett,
I'm embarking on a CD trap build and was looking where I could source all the parts from in the UK and come across your thread on here as you're from the UK too.
I see that you purchased the Mega pack from CD etsy shop which is something I may end up doing as well.
What printer did you print your trap on? I've got an Ender 3 v2 so was wondering if you printed yours on an ender 3 what orientation did you print the bottom plate in? When I load it into my slicer it comes right to the edge of the build plate. I wonder if you printed the full one or if you printed the cut one that's available in the thingiverse files.
Anyway, I want to congratulate you on your build. The end result is fantastic and it's threads like these that make me want to build this kind of thing.
Kindest Regards,
Brett
EctoLabs wrote: ↑March 7th, 2024, 11:33 am Hi Brett,Hi Dave,
I used an Ender 3 Pro which has the same build plate size as the v2. I also use Cura as my slicing software - the key with the bottom plate is to set your Build Plate Adhesion setting to 'None' as the software will try and add a skirt or brim by default which requires extra space around the model. Turning this off means you can use the entire width of the plate which is just enough for this part.
Hope that helps,
Dave
Using rip-stop cotton and custom dye for each char[…]